How to Setup Connection Between DTS Monaco and MB SD C4 DoIP

After Benz DTS Monaco software installation,you need configure DTS Monaco for interface (here take MB SD C4 DoIP as example).So here car-auto-repair.com show you guide on how to setup connection between DTS Monaco and MB SD C4 DoIP.

 

Preparations:

Benz DTS Monaco 8.16 8.08 Software Free Download

How to Install Mercedes Benz DTS Monaco 8.16 Software

 

Procedures:

After DTS Monaco installation,open network and sharing center

Setup-Connection-Between-DTS-Monaco-and-MB-SD-C4-DoIP-1

Click “Change adapter setting”

Setup-Connection-Between-DTS-Monaco-and-MB-SD-C4-DoIP-2

Right lick “Local Area Connection” and select “Properties”

Setup-Connection-Between-DTS-Monaco-and-MB-SD-C4-DoIP-3

Select “Internet Protocol Version 4 (TCP/IPv4)”—>”Properties”

Setup-Connection-Between-DTS-Monaco-and-MB-SD-C4-DoIP-4

Select “Use the following IP address”,and set address as below:

IP address:172.29.127.35

Subnet mask:255.255.255.0

Then click “Advanced…”

Setup-Connection-Between-DTS-Monaco-and-MB-SD-C4-DoIP-5

Click “Add”

Setup-Connection-Between-DTS-Monaco-and-MB-SD-C4-DoIP-6

Set address as below:

IP address:169.254.0.35

Subnet mask:255.255.0.0

Then click “Add”

Setup-Connection-Between-DTS-Monaco-and-MB-SD-C4-DoIP-7

Click “OK”

Setup-Connection-Between-DTS-Monaco-and-MB-SD-C4-DoIP-8

Click “OK”

Setup-Connection-Between-DTS-Monaco-and-MB-SD-C4-DoIP-9

And close

Setup-Connection-Between-DTS-Monaco-and-MB-SD-C4-DoIP-10

Now right click “Wireless Network”,then select “Properties”

Setup-Connection-Between-DTS-Monaco-and-MB-SD-C4-DoIP-11

Select “Internet Protocol Version 4 (TCP/IPv4)”—>”Properties”

Setup-Connection-Between-DTS-Monaco-and-MB-SD-C4-DoIP-12

Select “Use the following IP address”,and set address as below show

IP address:192.168.2.35

Subnet mask:255.255.255.0

Then click “OK”

Setup-Connection-Between-DTS-Monaco-and-MB-SD-C4-DoIP-13

Click “Close”

Setup-Connection-Between-DTS-Monaco-and-MB-SD-C4-DoIP-14

Now right click “SDconnect Toolkit” at lower right corner to select “Administration”

Setup-Connection-Between-DTS-Monaco-and-MB-SD-C4-DoIP-15

Click “Register/configure” option

It will show you the information as below.

Check off the “WLAN parameters,workshop” option

Select “Encryption” type to “WEP/Hex”

And set a Key:aaaaaaaaaaaaaaaaaaaaaaaaa

After then click “Start”

Setup-Connection-Between-DTS-Monaco-and-MB-SD-C4-DoIP-16

After finish it will show you a configuration information,close it.

Setup-Connection-Between-DTS-Monaco-and-MB-SD-C4-DoIP-17

And exit SDconnect Toolkit

Now you can run DTS Monaco with MB SD C4 DoIP.

(Visited 21 times, 1 visits today)