Categories: Auto Repair

VW RCD200/300/500 BLAUPUNKT Radio Decode by 2.5.8 pt geza

Sometime when your Volkswagen car radio replace battery or replace a used radio,you will find it will ask you to input password to unlock your car radio.In some situation,you forget the code,so here i will show you guide on how to unlock or decode Volkswagen RCD300 BLAUPUNKT Radio by 2.5.8 pt geza software.

 

Preparation:

2.5.8 pt geza Radio Unlocker

 

Procedures:

Remove cover and then locate 95640 chip on PCB

Then remove it and use programmer to read out the dump file and save it on our PC.

Run 2.5.8 pt geza software,then select “Blaupunkt RCD 200/300/500”

Click “Load dump bin file” button,then load the file you just saved on your PC

After then click “Get code” button

Now you can get the unlock code:0138

Install all parts back to RCD radio and power it,then input the code:0138

Now you will find it will be unlocked.

Done!

auto

Recent Posts

Doosan Machine Timeout Error of CAN Receive Frame AUXIO1

Here show you guide on how to solve Doosan machine Timeout error of CAN receive…

7 days ago

Liebherr Machine Emergency Stop-Ignition on While Emergency Stop is Active

This instruction show you guide on how to solve Liebherr machine emergency stop ignition on…

2 weeks ago

How to Solve Doosan Machine U043D CAN Receive Frame Counter Error

This instruction show you guide on how to solve Doosan machine trouble code U043D message…

3 weeks ago

AGCO Machine Trouble Code SPN 1485 – FMI 03 Solution

Here is the instruction show you guide on how to solve AGCO machine trouble code…

4 weeks ago

Detroit DD13 J1939 Wheel-Based Vehicle Speed Sensor Signal Missing

Detroit DD13 EPA10 (2010-13) trouble code SPN 84 FMI 13 (MCM) J1939 Wheel-based vehicle speed…

1 month ago

How to Solve Caterpillar C9 Vehicle Speed Signal Invalid?

This instruction show you guide on how to solve Caterpillar C9 engine trouble code 36…

1 month ago