This article i want to share the guide on how to repair VW/Audi/Skoda/Seat door lock control module trouble with DTCs 00929 and 00121.And if you have the trouble,you can not open the door with remote.
Firstly,connect VCDs cable to vehicle and run VW VCDS software enter to select control module
“52-Door Elect,Pass–>”Fault Codes-02”
You will find trouble code:
00929-Locking Module for Central Locking;Front Passenger Side (F221)
Remove the inner door panel
Take out the door lock.
Disassemble the lock to expose the electric motors.
Disassemble each motor and clean the brushes and collectors.
Reassemble all together,and install them back on vehicle
Run VCDS software again to read DTCs,show below and click “Clear Codes-05” to erase trouble codes.
Then try open door again,it can work correctly!!!
Here is the instruction show you guide on how to solve Caterpillar C9 fault code 64-2…
This instruction show you guide on how to bleed air from the fuel system for…
This instruction show you guide on how to solve Doosan and Bobcat Electric problems can…
It is necessary to do driver installation for JCB DLA 2.0 diagnostic kit,otherwise it can…
Here is the instruction show you guide on how to solve Deutz EMR3 engine fault…
This instruction show you guide on how to solve AGCO machine trouble code 138 SPN…