Categories: Auto Repair

Volvo V40 Start-Stop Not Working & Need Repairing

A Volvo V40 made 2013 got start-stop system trouble,it can not working and the dashboard get the massage “Start-stop need to be repaired”.

Trouble Diagnosis:

Use VIDA to diagnose the Volvo V40,it prompted that Center Electrical Module stored trouble code:U210929,it mean that:assistant battery trouble.

 

This trouble can be occur by below reasons:

Check engine fuse box fuse F19(work fine)

Start the engine,and detect the volotage of fuse F19,it showed 0V,it was unusual,normal value is battery voltage.

Remove the engine fuse box and found the fuse 70a was fused.

After replacing a new 70a fuse,but the trouble was still exist.

Check the wire harness between fuse F19 and CEM found the connecter terminal and inner PCB had damaged.

Vo

 

Solution:

Replacement new fuse 70a and CEM

auto

Recent Posts

JCB 3CX 4CX Backhoe Loader Engine Throttle Cable Removal and Replacement

JCB 3CX 4CX Backhoe Loader engine throttle cable is routed from the L.H. side of the…

3 days ago

How to Replace Fuel Tank Breather Filter Element for Liebherr R9600 Excavator

Here is the instruction show you guide on how to replace fuel tank breather filter…

3 weeks ago

FENDT 900 Vario COM III B092 Boost Pressure/Temperature Sensor

FENDT 900 Vario COM III tractor Component B092 - Sensor, charge air pressure/temperature reports the boost…

3 weeks ago

Deutz EMR3 Engine Trouble Code 87 / 97 / FlFCD WATER IN FUEL Solution

Deutz EMR3 Engine Trouble Code 87 / 97 / FlFCD WATER IN FUEL Solution Error description…

4 weeks ago

Kubota L3301 L3901 Tractor Hydraulic Flow Test Guide

This instruction show you guide on how to perform hydraulic flow test for Kubota L3301…

1 month ago

Bendix AutoVue FLC20 Camera LDW Configuration by JPRO

This instruction show you guide on how to configure Lane Departure Warning for Bendix AutoVue…

1 month ago