This instruction show you guide on how to use Launch X431 to code “Coming Home Time” for Volkswagen Passat 2012.More repair case about Passat,please check:Volkswagen Passat Repair
What You Need?
Prerequisites:
The ignition switch is on.
Battery voltage is kept above 12V.
The WiFi is good, otherwise, poor signal may cause diagnostic fault.
Procedures:
1.Choose Shanghai VW or a later version.
2.Choose System Selection.
3.Choose “09 Electric central electronic devices”.
4.The ECU information of 09 Electric central electronic devices is displayed.
5.Choose “10 Channel adjustment matching”.
6.Choose Read by List (if you choose Read by Channel, input the channel number 000).
7.Choose “023, go home time” and click OK.
8.The following values are displayed.
9.Here, increasing 2s is taken as an example. Click Value+ twice. The following values are displayed.
10.Click Save. Channel matching is successful. Click OK. Setting the go-home duration from 9.92s to 11.90s is successful.
More test report about Launch X431 please check:Launch X431 Test report
Detroit DD13 EPA10 (2010-13) trouble code SPN 84 FMI 13 (MCM) J1939 Wheel-based vehicle speed…
This instruction show you guide on how to solve Caterpillar C9 engine trouble code 36…
Kubota L3301 L3901 Excavator Safety Valve Setting Pressure Test Using Injection Nozzle Tester 1 Remove…
JCB Engine Fault Derate When a fault is detected, the ECU determines the severity of…
Here is a instruction show you guide on how to solve Liebherr ECU 2 D966…
AGCO EEM5 DEF Suction Module Tank sensor (CAN) The DEF suction module with the CAN-bus…