Categories: Auto Key Program

VCDS ProgramAdd New Keys for Audi A4 2001-2008

In this DIY guide,I will show you the procedures on how to use VCDS to do Audi A4 2001-2008 new key programming (need working key).

 

Preparations:

VCDS 17.8.1 Full+Loader V2/V4 Free Download

How to Configure VCDS & Diagnostic Cable for Your Laptop

How to Set Up VCDS Work on USBASP Programmer

 

Procedures:

Use working key turn the ignition on,then plug VCDS interface to vehicle obd port.

Run VCDS software,and select “Select Control Module”

Select “46-Central Conv”

After controller information reading,select “Adaptation 10”

Select “Read”àclick “Save” buttonàClick “Yes” to save

 

Change channel value to “21”,and select new value to “1”,and click “Test” button

Now pree “lock” button on you new remote fob,the VCDS will show the “Adjustment” to ”Recognized”

Now save the value

 

After you saving value,click read button again

And change new value “2”,and click “Test” button

Press the “Lock” button of the working key that you insert in ignition

Adjustment-à”Recognized”

Now click to save value again

Go back and close controller

Now test both keys,both of them can work normally.

Done!

 

Audi A4 2001-2008 Remote Matching 8E/8H Chassis Code by VCDS

auto

Recent Posts

How to Solve Liebherr Machine Power or Speed Reduction?

How to solve Liebherr machine trouble code P1188 power or speed reduction emission related failure.…

5 days ago

Doosan Machine Timeout Error of CAN Receive Frame AUXIO1

Here show you guide on how to solve Doosan machine Timeout error of CAN receive…

2 weeks ago

Liebherr Machine Emergency Stop-Ignition on While Emergency Stop is Active

This instruction show you guide on how to solve Liebherr machine emergency stop ignition on…

3 weeks ago

How to Solve Doosan Machine U043D CAN Receive Frame Counter Error

This instruction show you guide on how to solve Doosan machine trouble code U043D message…

4 weeks ago

AGCO Machine Trouble Code SPN 1485 – FMI 03 Solution

Here is the instruction show you guide on how to solve AGCO machine trouble code…

1 month ago

Detroit DD13 J1939 Wheel-Based Vehicle Speed Sensor Signal Missing

Detroit DD13 EPA10 (2010-13) trouble code SPN 84 FMI 13 (MCM) J1939 Wheel-based vehicle speed…

2 months ago