In this instruction car-auto-repair.com show you guide on how to remove and install steering angle sensor for Suzuki Grand Vitara JB416 JB420.
Related Content:
2019 2014 Suzuki Worldwide Automotive EPC Free Download
Removal
1) Remove steering wheel and contact coil cable assembly. Refer to “Steering Wheel Removal and
Installation: in related manual” and “Contact Coil Cable Assembly Removal and Installation: ”.
2) Remove steering angle sensor (2) from contact coil cable assembly (3) while opening fitting parts (1) of contact coil cable assembly.
Installation
1) Install steering angle sensor (2) by fitting engagement parts (1) of contact coil cable assembly
to claws of steering angle sensor as shown in figure.
2) Install contact coil cable assembly and steering wheel.
Here show you guide on how to solve Doosan machine Timeout error of CAN receive…
This instruction show you guide on how to solve Liebherr machine emergency stop ignition on…
This instruction show you guide on how to solve Doosan machine trouble code U043D message…
Here is the instruction show you guide on how to solve AGCO machine trouble code…
Detroit DD13 EPA10 (2010-13) trouble code SPN 84 FMI 13 (MCM) J1939 Wheel-based vehicle speed…
This instruction show you guide on how to solve Caterpillar C9 engine trouble code 36…