This instruction show you guide on how to use iProg pro programmer to change odometer value for Renault ATE ABS/ESC/CDC/ESP by OBD.More Renault cases,please refer to:Renault Trouble Repair.
Preparations:
Newest iProg Pro Plus iProg+ v84 v82 Free Download
Procedures:
Connect iProg Plus programmer to Renault vehicle obd port.
Then run software to select “Renault_ATE_ABS_OBD2”
Click “Read EEPROM”
Then reading data done,it will show you current milage:94313
Input new value:12345
Click “Change KM”,then click “Write EEPROM”
It will ask you if write whole EEPROM or modified bytes
Click “No” to write modified bytes only
After writing done,click “Read EEPROM” again to check if new value KM is valid
Detroit DD13 EPA10 (2010-13) trouble code SPN 84 FMI 13 (MCM) J1939 Wheel-based vehicle speed…
This instruction show you guide on how to solve Caterpillar C9 engine trouble code 36…
Kubota L3301 L3901 Excavator Safety Valve Setting Pressure Test Using Injection Nozzle Tester 1 Remove…
JCB Engine Fault Derate When a fault is detected, the ECU determines the severity of…
Here is a instruction show you guide on how to solve Liebherr ECU 2 D966…
AGCO EEM5 DEF Suction Module Tank sensor (CAN) The DEF suction module with the CAN-bus…