This mini post show you guide on how to remove and disassemble instrument cluster for Dodge Caliber 2006-2009.This guide and many other cases please refer to:
DashBook Pro v7.9+SRSBook 1.4 2018 Removal Book 100% Work Solution
Removing the instrument cluster
Remove center console holds snap of iron
Unscrew the two screws
Next,disassemble the lower trim on the left side (in the legs of the driver),it is necessary to unscrew the safety cushion for the knees have to Dodge,and the inside panel of 10 small key unscrew the two nuts.
Unscrew the 2 screws
Remove side plates on the right and left sides,unscrew the two screws on the left and marked the third from the top,which holds the top panel.
Remove screw below
Next you need to remove the passenger pillow,the same key to Dodge by himself plastic
Unscrew the 3 screws in the upper glove box
Poddevaem and carefully remove the trim nlay is near the windshield
Unscrew the remaining screws
Remove the upper trim
Remove the 4 screws and remove the instrument cluster
Access MC9S12H256,remove the back cover
Detroit DD13 EPA10 (2010-13) trouble code SPN 84 FMI 13 (MCM) J1939 Wheel-based vehicle speed…
This instruction show you guide on how to solve Caterpillar C9 engine trouble code 36…
Kubota L3301 L3901 Excavator Safety Valve Setting Pressure Test Using Injection Nozzle Tester 1 Remove…
JCB Engine Fault Derate When a fault is detected, the ECU determines the severity of…
Here is a instruction show you guide on how to solve Liebherr ECU 2 D966…
AGCO EEM5 DEF Suction Module Tank sensor (CAN) The DEF suction module with the CAN-bus…