Here is the instruction show you guide on how to use JPRO to perform evaluate NOx sensor test for Paccar EPA 13 all MX engines.
Related Contents:
2024 JPRO Noregon Commercial Fleet Diagnostics Free Download
The Evaluate NOx Sensors Test is supported on:
✓ Paccar EPA 13 all MX engines.
This test is used to verify the accuracy and functionality of the SCR system’s NOx sensors.
The tip of the NOx sensor will become extremely hot during the test and must be suspended away from anything flammable or sensitive to heat.
1 Select the Evaluate NOx Sensors Test and press Enter or click the Start button.
2 The test dialog will be displayed.
3 Select the sensor to test and click the Start button to begin the test.
4 The Start button will change to a Stop button and the lamp next to the button will indicate the test is Running.
5 During the procedure, the status is monitored and updated in the Status window. The NOx sensor will heat for approximately 10 minutes before sensor evaluation.
6 Select the Stop button to stop the test at any point.
7 Once the test has been completed, click the Exit button. A warning to allow the NOx sensor to cool before reinstallation is displayed. Click OK to return to the test selection dialog.
More topics about JPRO Diagnostic,please refer to:JPRO Diagnostics Guide
This instruction show you guide on how to solve Caterpillar C9 engine trouble code 36…
Kubota L3301 L3901 Excavator Safety Valve Setting Pressure Test Using Injection Nozzle Tester 1 Remove…
JCB Engine Fault Derate When a fault is detected, the ECU determines the severity of…
Here is a instruction show you guide on how to solve Liebherr ECU 2 D966…
AGCO EEM5 DEF Suction Module Tank sensor (CAN) The DEF suction module with the CAN-bus…
This instruction show you guide on how to remove the threshing drum for CLAAS Lexion…