Categories: Auto Knowledge

Opel Vehicle Data Link Connector Location Collection

Here show Opel vehicle data link connector location,hope it is helpful to diy beginners.And if you are interest in Opel projects,check here:Opel Trouble Repair

 

 

Cavalier / Calibra / Omega-A DLC Location

Located in the engine compartment (old style, requires 10 to 16 pin adapter)

 

Corsa B / Astra F / Tigra DLC Location

Located in the fuse box near the driver. Depending on the model it is a 10-pin or 16-pin

diagnostic plug.

 

Omega-B DLC Location

Located in the fuse box near the driver.

 

Vectra-B DLC Location

Located under the handbrake lever. Lift up the trim panel under the lever to access it.

 

Astra G / Zafira DLC Location

Located under the handbrake lever. Lift up the trim panel under the lever to access it.

 

Corsa C / Meriva / Tigra-B DLC Location

Located under the heater controls. It is recessed in the lower part of the panel (take extra

care inserting the interface)

 

Vectra C / Signum DLC Location

Located underneath the ashtray. The ashtray must be removed for access.

 

Astra-H DLC Location

Located under the handbrake lever. Lift up the trim panel under the lever to access it.

 

Zafira-B DLC Location

Located behind the ashtray near the gear lever in the centre console.

 

Corsa D DLC Location

Located underneath the heater control panel.

 

Vivaro DLC Location

Located underneath the steering wheel. Remove cover to access the socket.

auto

Recent Posts

MANITOU MT6034 Telehandlers PWP System Deactivation Tests

This instruction show you guide on how to do deactivation test for MANITOU MT6034 telehandlers…

3 days ago

How to Solve Liebherr Machine ECU2 P1119 SCR System Plausibility Error

This instruction show you guide on how to solve Liebherr machine ECU2 P1119-00 trouble code…

4 days ago

Bobcat Machine P18A5 Suction Line Heater Open Error Solution

This instruction show you guide on how to solve Bobcat machine trouble code P18A5 suction…

1 week ago

AGCO Machine SPN 102 – FMI 31 Intake Manifold Pressure Drop Too High at Cranking

The measured intake manifold pressure (signal from boost pressure sensor) is below the warning limit…

2 weeks ago

JCB 3CX 4CX Backhoe Loader Engine Throttle Cable Removal and Replacement

JCB 3CX 4CX Backhoe Loader engine throttle cable is routed from the L.H. side of the…

2 weeks ago

How to Replace Fuel Tank Breather Filter Element for Liebherr R9600 Excavator

Here is the instruction show you guide on how to replace fuel tank breather filter…

1 month ago