Categories: Auto RepairHow To

OPCOM VAXU-COM Airbag Coding Guide for Opel

The new airbag control ECU is not configured. When a new airbag ECU is fitted to a car, it must be configured in order to work properly. OP-COM currently supports the coding of SAB6, and SAB8 airbag control units.This article from car-auto-repair.com is about OPCOM VAXU-COM Airbag Coding Guide for Opel.

 

What You Need?

Newest OPCOM VAUX-COM All Version Free Download

OPCOM Clone

 

Since the airbag is part of the vehicle safety system, always follow the on-screen instruction.

Please, always read the repair manual of the car, and strictly follow all the given procedures!

Important: The airbag ECU can be coded only once, when it is new. After the first successful configuration, the configuration cannot be altered, or changed!

 

In this example, I’ll show you the airbag coding of a SAB6 ECU, on a MY99 Astra-G.

 

When you select an airbag (SAB6, or SAB8 system), the following window will appear:

Please, first click on the [Fault Codes] button, to see the list of the fault codes

You can see from the Fault Code list, that the Airbag ECU needs to be programmed.

 

Please click on the [Back] button, and then click on the [Programming] button, to go to the programming menu. Depending on your selection, the following windows will be shown:

 

When you selected the proper configuration, please click on the [Perform Coding] button, to perform the programming of the Airbag ECU.

If the programming was successful, you will see the following message box:

If the programming failed, you will see the following message box:

If something went wrong with the communication during programming, you will see the following message box:

When the programming has been completed, please clear the fault codes, and close the
communication with the Airbag ECU. The airbag lamp should goes out, and must stay OFF, if
the programming was successfully, and there is no fault in the airbag system. If the airbag
lamp goes OFF, and then goes ON immediately, there must be some problem with the airbag
system. Please read out the fault codes, and correct the problem.

 

auto

Recent Posts

How to Solve Liebherr Machine Power or Speed Reduction?

How to solve Liebherr machine trouble code P1188 power or speed reduction emission related failure.…

4 days ago

Doosan Machine Timeout Error of CAN Receive Frame AUXIO1

Here show you guide on how to solve Doosan machine Timeout error of CAN receive…

2 weeks ago

Liebherr Machine Emergency Stop-Ignition on While Emergency Stop is Active

This instruction show you guide on how to solve Liebherr machine emergency stop ignition on…

3 weeks ago

How to Solve Doosan Machine U043D CAN Receive Frame Counter Error

This instruction show you guide on how to solve Doosan machine trouble code U043D message…

4 weeks ago

AGCO Machine Trouble Code SPN 1485 – FMI 03 Solution

Here is the instruction show you guide on how to solve AGCO machine trouble code…

1 month ago

Detroit DD13 J1939 Wheel-Based Vehicle Speed Sensor Signal Missing

Detroit DD13 EPA10 (2010-13) trouble code SPN 84 FMI 13 (MCM) J1939 Wheel-based vehicle speed…

2 months ago