This instruction show you guide on how to use iProg programmer to do odometer correction for Nissan Qashqai 2010 9S12XHZ256 via obd2.
Related Contents:
Newest iProg Pro Plus iProg+ v87 v84 v82 Free Download
Procedures:
Connect iProg programmer to Nissan Qashqai 2010 OBD port
Then run iProg software,select “Nissan Qashqai 9S12XHZ256_OBD2.ipp”
Click “Read EEPROM”,then it will show you message “For read EEPROM need patch flash.”
Press “Yes” for start patch flash or “No” for cancel.
Wait reading flash
Read Flash finish,and it will save backup and wait processing
Erase flash
Write flash
After reading processing finish,now here input new value in “Mileage”
Then click “WriteEEPROM” and wait processing
Write EEPROM ok show in message box
Now dashboard restart,new value show on mileage value
Done!
More topics for iProg,please refer to:iProg test feedback
It is necessary to do driver installation for JCB DLA 2.0 diagnostic kit,otherwise it can…
Here is the instruction show you guide on how to solve Deutz EMR3 engine fault…
This instruction show you guide on how to solve AGCO machine trouble code 138 SPN…
Here is the instruction show you guide on how to install the left-hand drum bearing…
This instruction show you guide on how to remove and replace loader lift ram for…
This instruction show you guide on how to solve Caterpillar C9 engine 31 84-1 fault…