Categories: Auto Repair

Needle Sweep staging calibration by VCDS for Seat Leon

This instruction show you guide on how to use VCDS to calibrate dashboard needle sweep staging.For more VCDS projects,please check here:VCDS Test Feedback.

Preparations:

How to Configure VCDS & Diagnostic Cable for Your Laptop

VCDS 17.8.1 Full+Loader V2/V4 Free Download

 

Steps:

Connect VCDS cable to your vehicle,then run software and click “Select Control Module”

Select “17-Instruments”

Select “Adaptation-10”

Scroll down and search for “ IDE01087-Staging”

Find “New Value” and hit it, select “Active”

Select “Do It” and “Yes”

It shows controller accepted the request, will now read the channel again…. Hit “OK”

Hit “Go Back” , Now calibration is done.

 

If you want to know more about Seat Neon, please refer to Seat trouble repair.

 

 

auto

Recent Posts

How to Solve Liebherr Machine Power or Speed Reduction?

How to solve Liebherr machine trouble code P1188 power or speed reduction emission related failure.…

2 days ago

Doosan Machine Timeout Error of CAN Receive Frame AUXIO1

Here show you guide on how to solve Doosan machine Timeout error of CAN receive…

1 week ago

Liebherr Machine Emergency Stop-Ignition on While Emergency Stop is Active

This instruction show you guide on how to solve Liebherr machine emergency stop ignition on…

2 weeks ago

How to Solve Doosan Machine U043D CAN Receive Frame Counter Error

This instruction show you guide on how to solve Doosan machine trouble code U043D message…

3 weeks ago

AGCO Machine Trouble Code SPN 1485 – FMI 03 Solution

Here is the instruction show you guide on how to solve AGCO machine trouble code…

4 weeks ago

Detroit DD13 J1939 Wheel-Based Vehicle Speed Sensor Signal Missing

Detroit DD13 EPA10 (2010-13) trouble code SPN 84 FMI 13 (MCM) J1939 Wheel-based vehicle speed…

1 month ago