After replacing new tire pressure sensors for cars,it requires to perform programming TPMS.So here i will show you guide on how to use Launch X431 to program tire pressure sensors for Land Rover 2014. More about Land Rover projects,please refer to:Land Rover Trouble Repair
What You Need?
Procedures:
1.Pease remember new ID：0F001100, then start to replace. Use auto search function, make sure all information is right choose “Yes”
2.Choose “System selection”
3.Choose “Body control module”
4.Choose “Special function”
5.Choose”Tire pressure sensor relpacement”
6.Choose “Standard wheel with tire pressure sensor / transmitter”
7.Choose “Rgiht rear tire sensor”
8.Switch on igition press “Yes”
9.Press “Yes” to continue
10.Press “Yes”
11.Input new sensor ID:0F001100
12.Turn off the ignition press “Yes”
13.After turn off ignition 15 mins, drive the car above 20KM/H for 15 mins least to test
14.The fault light goes out.
More test report about Launch X431 please check:Launch X431 Test report
Detroit DD13 EPA10 (2010-13) trouble code SPN 84 FMI 13 (MCM) J1939 Wheel-based vehicle speed…
This instruction show you guide on how to solve Caterpillar C9 engine trouble code 36…
Kubota L3301 L3901 Excavator Safety Valve Setting Pressure Test Using Injection Nozzle Tester 1 Remove…
JCB Engine Fault Derate When a fault is detected, the ECU determines the severity of…
Here is a instruction show you guide on how to solve Liebherr ECU 2 D966…
AGCO EEM5 DEF Suction Module Tank sensor (CAN) The DEF suction module with the CAN-bus…