The engine MIL is on; sometimes, the engine is hard to ignite, which shall go to the workshop to
repair. After replaced the diesel lattice and drained the water, carry out the reset of the detection of water in fuel.So here I will show you a guide on how to use Launch X431 to reset of the detection of water in fuel of Launch Rover New Freelander 2 2013.More about Land Rover projects,please refer to:Land Rover Trouble Repair
What You Need?
Operations:
1.Select Land Rover V32.82 or above
2.It indicates the operator info. Confirm the vehicle model is correct
3.Check the vehicle info, and click Yes to continue, select system selection
4.Select Special Function
5.Select “Reset of the Detection of Water in Fuel”. This procedure is required after drained the water to reset the mileage and the distance, which is related to the monitoring of water in fuel.The water must be drained manually from the fuel system before this normal procedure runs.Then click Confirm to continue
6.Turn the ignition on (Position 2), then click Confirm to continue
7.This procedure is the “Reset of the Detection of Water in Fuel”, then click Confirm to continue
8.The Reset of the Detection of Water in Fuel is completed, then click Confirm to continue
9.Turn the ignition off (Position 0) as indicated, then click Confirm to continue
10.Turn the ignition on (Position 2) as indicated, then click Confirm to continue
11.It indicates to clear all DTCs of the vehicle in the next step. Continue? Click Yes to continue
12.Turn the ignition off (Position 0) as indicated, then click Confirm to continue
13.Turn the ignition on (Position 2) as indicated, then click Confirm to continue
14.It indicates “Control module procedure successfully completed”, then click Confirm to continue
15.Turn the ignition off (Position 0) as indicated, and then click Confirm; At this time, the special function Reset of the Detection of Water in Fuel completed.
More test report about Launch X431 please check:Launch X431 Test report
Detroit DD13 EPA10 (2010-13) trouble code SPN 84 FMI 13 (MCM) J1939 Wheel-based vehicle speed…
This instruction show you guide on how to solve Caterpillar C9 engine trouble code 36…
Kubota L3301 L3901 Excavator Safety Valve Setting Pressure Test Using Injection Nozzle Tester 1 Remove…
JCB Engine Fault Derate When a fault is detected, the ECU determines the severity of…
Here is a instruction show you guide on how to solve Liebherr ECU 2 D966…
AGCO EEM5 DEF Suction Module Tank sensor (CAN) The DEF suction module with the CAN-bus…