JCB StageV engine Coolant pressure sensor voltage above normal or open circuit.The measured coolant pressure sensor voltage signal is above the normal operating range..
Related Contents:
WinEEM4s JCB Service Tool 2.7.2 2.6.1 Free Download
2024 JCB ServiceMaster 4 v24.6.2 Free Download for Win 10 Win11
2017 JCB Parts Plus+ and Repair Service Manual Free Download
Possible causes are:
The coolant pressure sensor wiring is defective. (Shorted to high source or an open circuit.)
The coolant pressure sensor is defective.
Reaction in EEM
The FC is stored and the warning lamp is activated. The CAN message indicates active fault.
Solution
First save the error log and then erase it. Restart the ECU after erasing the error log. If the fault occurs again during the next driving cycle, check the following paths:
Check the coolant pressure sensor wiring, the connectors and the contact surfaces of the connector pins (possible oxidation).
Check the operation with another coolant pressure sensor to see if the coolant pressure sensor is defective.
More repair case for JCB,please refer to:JCB Trouble Repair
Here is a instruction show you guide on how to solve Liebherr ECU 2 D966…
AGCO EEM5 DEF Suction Module Tank sensor (CAN) The DEF suction module with the CAN-bus…
This instruction show you guide on how to remove the threshing drum for CLAAS Lexion…
This instruction show you guide on how to display service menu for Hitachi ZX890-7 excavator.…
Here is the instruction show you guide on how to do Advanced Tool Select and Basic…
Here car-auto-repair.com show you guide on how to solve P1161 trouble code on resistance error…