This instruction show you guide on how to repair JCB equipment K4716 trouble code:Intake pressure sensor signal is not plausible.More repair case for JCB,please refer to:JCB Trouble Repair
Related Content:
WinEEM4s JCB Service Tool 2.7.2 2.6.1 Free Download
2024 JCB ServiceMaster 4 v24.3.1 Free Download for Win 10 Win11
The EEM monitoring system has detected that the intake pressure sensor value is implausible.
Possible causes are:
The boost air piping is leaking.
The EGR pipe is leaking.
The boost pressure sensor is blocked.
Reaction in EEM
The FC is stored and the warning lamp is activated. Engine power will be reduced (Degradation Level 2). The CAN message indicates active fault.
Solution
First save the error log and then erase it. Restart the ECU after erasing the error log. If the fault occurs again during the next driving cycle, check the following paths:
Check the boost air system tightness (piping, intercooler).
Check the turbo waste gate flap and the condition of the actuator. The actuator should move in the ECU initialization.
Check the condition of the turbo charger.
This instruction show you guide on how to remove the threshing drum for CLAAS Lexion…
This instruction show you guide on how to display service menu for Hitachi ZX890-7 excavator.…
Here is the instruction show you guide on how to do Advanced Tool Select and Basic…
Here car-auto-repair.com show you guide on how to solve P1161 trouble code on resistance error…
AGCO EEM Dosing module Description The dosing module (DM) is installed in the exhaust…
Here is the instruction show you guide on how to solve Caterpillar C9 fault code 64-2…