JCB 3CX/4CX/5CX Loader Hand Throttle Position Sensor Service Steps

Here is the illustration show the service steps for JCB Backhoe Loaders 3CX/4CX/5CX hand throttle position sensor.

 

Related Contents:

WinEEM4s JCB Service Tool 2.7.2 2.6.1 Free Download

2024 JCB ServiceMaster 4 v24.6.2 Free Download for Win 10 Win11

2017 JCB Parts Plus+ and Repair Service Manual Free Download

 

 

Function

Determines hand throttle position set by the operator.

 

Location

On Backhoe Loader machines, the hand throttle position sensor is mounted under the front console.

 

Signal

Analogue voltage between 0 volts and 5 volts.  Voltage output proportional to throttle lever position. Two throttle tracks are used to ensure safety of the operator in the case of throttle malfunction.

 

 

Internal Electrical Schematic

 

Testing

Important: Use the multi-meter on the harness connector pins. DO NOT use the meter on the ECU pins. (SN0011)

1 Disconnect the sensor.

2 Switch the ignition ON.

3 Check supply voltage is 5 volts (pins 1 and 4). Connector pin 3 and 6 should read ground (0 volts).

4 If voltages are incorrect, check harness for continuity and ground conditions, check ECU pins for evidence of contamination or corrosion.

5 Measure signal voltage from the throttle position sensor when the throttle is at idle.

a)Pin 2 = 1.0 to 1.2 volts.

b)Pin 5 = 0.4 to 0.6 volts.

6 Measure signal voltage when throttle is fully depressed.

a)Pin 2 – 4.0 to 4.5 volts.

b)Pin 5 – 2.2 to 2.5 volts.

 

Related Fault Codes

 

More repair case for JCB,please refer to:JCB Trouble Repair