International EPA 10 Maxxforce DT, 9/10 Engines CDPF Reset by JPRO

JPRO CDPF Reset is an aftertreatment reset request that provides the ability to reset the soot level after an aftertreatment component has been cleaned or replaced.

 

Related Contents:

2024 JPRO Noregon Commercial Fleet Diagnostics Free Download

Noregon JPRO DLA+ 2.0 Adapter

 

 

CDPF Reset is supported on:
✓ International EPA 10 Maxxforce DT, 9 and 10 engines.

1. Select CDPF Reset and press Enter or the Start button.

2. The Configure Monitored Data for CDPF Reset dialog will be displayed.

3. Select parameters from the Available list and click > Add > button to move them to the Selected list.
4. To remove parameters from the Selected list, highlight the parameter in the list and press the < Remove <button. The parameter will be returned to the Available list.
5. When you are done selecting parameters, then press the OK button, otherwise press the Cancel button to return to the test selection dialog.
6. Pressing OK button will cause the CDPF Reset dialog to be displayed

7. Select the Reset button to initiate the reset operation. Follow the instructions given on the dialog.
8. Turn off the ignition and select the OK button (previously was the Reset button).
9. Wait for the displayed timer progress to complete. When complete, the Exit button is enabled and the instruction to ‘Please turn ignition on to re-establish communications.’ displays.
10. Turn the ignition on. Wait for communication to be re-established.
11. Once the status updates to ‘Procedure Successfully Completed’, press Exit to return to the test selection dialog.

 

More topics about JPRO Diagnostic,please refer to:JPRO Diagnostics Guide