The Aftertreatment Hydrocarbon Dosing System Test is used to verify proper operation of the aftertreatment hydrocarbon doser. It allows for inspection of the spray pattern and quantity of fuel dispensed.
The aftertreatment hydrocarbon doser must be removed and the mounting hole capped before running this test to prevent vehicle damage.
Related Contents:
2024 JPRO Noregon Commercial Fleet Diagnostics Free Download
Procedures:
1 Select Aftertreatment Hydrocarbon Dosing System Test and press Enter or the Start button.
2 The test dialog will be displayed.
3 Once all instructions have been followed and preconditions have been met, click the Next button to proceed.
4 Select a Delay Start Time, if desired, and click the Start button to begin the test. The hydrocarbon doser should start pumping out fuel into the measuring container over a period of 3 minutes.
5 The dialog displays examples of correct and problem spray patterns that can be detected by observing the doser as it dispenses fuel into the collection container.
6 When the test is completed, results information is displayed, including steps to take depending on how much fuel was dispensed.
7 If desired, you may select the Rerun button to rerun the test.
8 Once the test has been completed, click the Exit button to return to the test selection dialog.
More topics about JPRO Diagnostic,please refer to:JPRO Diagnostics Guide
Here is the instruction show you guide on how to solve Deutz EMR3 engine fault…
This instruction show you guide on how to solve AGCO machine trouble code 138 SPN…
Here is the instruction show you guide on how to install the left-hand drum bearing…
This instruction show you guide on how to remove and replace loader lift ram for…
This instruction show you guide on how to solve Caterpillar C9 engine 31 84-1 fault…
This instruction show you guide on how to charge and discharge accumulator for JCB 3CX,…