How to Use XPROG Programmer Reset VW Golf 7 MK7 SPC560 Airbag

This article show you guide on how to use XPROG programmer to reset airbag module for Volkswagen Golf7 MK7.

 

Preparations:

Newest XPROG v5.84 Software Free Download

XPROG v5.84 Programmer Interface

 

Procedures:

Remove airbag module from Golf 7

Follow below diagram connection to build wire connection

Then connect XPROG to your PC and run XPROG software

And then click “Device” button

Select “MCU/MPU”–>”SPC560”–>”SPC560P50LxData_Flash”

Click “Read” button

Wait for reading proceed…

After the click “Save” button to save the airbag file on your PC to make a backup

 

Then you need a airbag reset software you reset the data file you read out from airbag module

After then you need use XPROG to write the airbag data flash file that have been reset back to airbag module.

Install the airbag back on vehicle!