Here is a easy way to configure BMW Rheingold ISTA to connect ICOM diagnostic interface.
Preparations:
BMW ITool Radar Free Download and Installation
2024.08 BMW Rheingold ISTA+ 4.48.40 4.23.14 ISTA-P 3.71 Free Download
Procedures:
Run iTool Radar software
Click the “Free” device state,then click “Function” button right side,it will show “release”.
Now the color will change from green to red,it mean BMW ICOM connection built connection successfully.
Note:Record the IP address show above
Detroit DD13 EPA10 (2010-13) trouble code SPN 84 FMI 13 (MCM) J1939 Wheel-based vehicle speed…
This instruction show you guide on how to solve Caterpillar C9 engine trouble code 36…
Kubota L3301 L3901 Excavator Safety Valve Setting Pressure Test Using Injection Nozzle Tester 1 Remove…
JCB Engine Fault Derate When a fault is detected, the ECU determines the severity of…
Here is a instruction show you guide on how to solve Liebherr ECU 2 D966…
AGCO EEM5 DEF Suction Module Tank sensor (CAN) The DEF suction module with the CAN-bus…