When replacing certain components,a teach-in procedure is needed for a complete repair and correct function of the system.This function is used to program the fuel pressure sensor.In this instruction,car-auto-repaircom will show you guide on Opel Astra J 1.7 CDTi Learn Fuel Pressure Regulator by Delphi Ds150e.
Procedures:
Connect you DS150E interface to Opel and computer
Then run DS150E software,and select vehicle
Opel/Vaxuhall–>Astra J–>2011(VIN 10=B)
Diesel–>A17DTR 1.7L–>E21(LPL)
Gearbox MT/AT
Then click “OBD” button
It will ask you to do below operations
1.Turn ignition on or start the engine
2.Start measuring
3.Choose the test or tests you want to perform
4.Exit measuring
5.Turn ignition off
Click “DTC” button
It show you with the P062A
Fuel pressure regulator
Not learned
Intermittent
Select right adjustment button and select “Learn Fuel Pressure Regulator”
It will show you the test conditions,check and then click “OK” to continue
1.Ignition on,engine off-the engine is started during the procedure.
2.Coolant temperature 600-100℃
3.System voltage 8-10V
4.Fuel temperature 20-60℃
It will ask you to start engine and run it at idle speed,follow and click “OK” button
It will take approximately 60 seconds
Learning in progress
Now Opel fuel pressure regulator learning complete.You can back to DTC function to erased the trouble code.
Detroit DD13 EPA10 (2010-13) trouble code SPN 84 FMI 13 (MCM) J1939 Wheel-based vehicle speed…
This instruction show you guide on how to solve Caterpillar C9 engine trouble code 36…
Kubota L3301 L3901 Excavator Safety Valve Setting Pressure Test Using Injection Nozzle Tester 1 Remove…
JCB Engine Fault Derate When a fault is detected, the ECU determines the severity of…
Here is a instruction show you guide on how to solve Liebherr ECU 2 D966…
AGCO EEM5 DEF Suction Module Tank sensor (CAN) The DEF suction module with the CAN-bus…