How to Test Main Relief Valve for Bobcat 3450 Utility Vehicle

This post show you the steps on how to test Bobcat 3450 Utility Vehicle main relief valve working status.

 

Related Contents:

Bobcat 3450 Utility Vehicle Fuel Injector Removal and Installation Guide

2023 Bobcat Service Analyzer 91.15 91.05 Diagnostic Free Download

 

How to Test Main Relief Valve

Remove the plug (Item 1) from the PS port

Install a 90° fitting (Item 1) into PS port.

Install a 20,7 MPa (206,8 bar) (3000 psi) gauge (Item 1) on the 90° fitting.
Turn the key switch ON.
Press the bottom of the attachment arm lock switch to engage the joystick.
Raise the arm until the lift arm is fully retracted and the relief valve opens.
The main relief valve pressure should be 10,3 MPa (103,4 bar) (1500 psi).
The main relief valve (Item 2) is not adjustable and must be replaced if out of tolerance.
Installation: Tighten the main relief valve to 16,4 – 17 N•m (145 – 165 in-lb) torque.

More repair topic for Bobcat,please refer to:Bobcat Excavator Repair