Here is the instruction show you guide on how to JCB machine SPN 102,FMI 1 boost pressure sensor:pressure below normal.
Related Contents:
2025 JCB ServiceMaster 4 v25.1.0 Free Download for Win 10 Win11
JCB ECU’s All Modules Flash File Download 10.2025
2025 WinEEM5 9.0 and WinEEM4s JCB Service Tool
Cause
Boost pressure sensor, boost pressure out of range. Possible causes are a leaking boost air pipe, a clogged exhaust line (DOC/DPF/SCR), a defective turbocharger, a defective wastegate actuator, or the engine is mechanically defective.
Consequences and remedy
Save the engine all log file.
Examine that the boost air system (piping and intercooler) is not leaking.
Examine that the fresh air-intake and air filter pressure alarm switch is not active.
Examine that the exhaust line is not clogged.
Remove the DEF dosing module from the exhaust line and examine the condition of the mixer.
Examine the condition of the turbocharger.
More topics for JCB machine,please refer to:JCB Machine Trouble Repair.
It is necessary to do driver installation for JCB DLA 2.0 diagnostic kit,otherwise it can…
Here is the instruction show you guide on how to solve Deutz EMR3 engine fault…
This instruction show you guide on how to solve AGCO machine trouble code 138 SPN…
Here is the instruction show you guide on how to install the left-hand drum bearing…
This instruction show you guide on how to remove and replace loader lift ram for…
This instruction show you guide on how to solve Caterpillar C9 engine 31 84-1 fault…