Caterpillar PEEC certain parameters may not be programmable if the Communication Adapter II or CAT Communication Adapter III is connecting the service tool to the Programmable Electronic Engine Control (PEEC).
Related Contents:
Caterpillar ET 2024A 2023C 2019C 2018A Software Free Download
Caterpillar Factory 18 Digits Password Service
If this occurs, perform the following steps:
1 Locate the 9-pin connector (diagnostic connector). Refer to the engine’s schematics.
Note: For PEEC engines, the diagnostic connector is J1. For PEEC III engines, the diagnostic connector is J8.
2 Locate Pin F. This is the pin used for programming. It must be grounded in order to change parameters.
3 Install a jumper between Pin B and Pin F, or connect Pin F to engine ground. Ensure that existing wires remain connected to the 9-pin connector.
If Pin F is not properly grounded, some of the following parameters will be affected: Engine Serial Number, Personality Module Code, Full Load Setting, and Full Torque Setting.
This instruction show you guide on how to solve Liebherr machine emergency stop ignition on…
This instruction show you guide on how to solve Doosan machine trouble code U043D message…
Here is the instruction show you guide on how to solve AGCO machine trouble code…
Detroit DD13 EPA10 (2010-13) trouble code SPN 84 FMI 13 (MCM) J1939 Wheel-based vehicle speed…
This instruction show you guide on how to solve Caterpillar C9 engine trouble code 36…
Kubota L3301 L3901 Excavator Safety Valve Setting Pressure Test Using Injection Nozzle Tester 1 Remove…