This post show you guide on how to repair BMW CID “NO signal” after BMW EVO main unit coding.
Preparations:
How to Configure Connection Port for BMW E-sys Software
BMW E-sys 3.33.0/3.32.1/3.30.01 Coding Software Free Download
Procedures:
Change EVO hidden codes
CID_APIX_MODE change to apix1
CID_COLOR_DEPTH change to 18
CID_COM_MODE change to spi
For F18 without screen replacement,so it need to change the resolution
Video cable need use buck line,CID_display_res change to 1280_480
For series low-profile instrument,you need to change below codes
BASIS_KOMBI_MMI change to aktiv
Kombi_cic change to kombi_low
JCB 3CX 4CX Backhoe Loader engine throttle cable is routed from the L.H. side of the…
Here is the instruction show you guide on how to replace fuel tank breather filter…
FENDT 900 Vario COM III tractor Component B092 - Sensor, charge air pressure/temperature reports the boost…
Deutz EMR3 Engine Trouble Code 87 / 97 / FlFCD WATER IN FUEL Solution Error description…
This instruction show you guide on how to perform hydraulic flow test for Kubota L3301…
This instruction show you guide on how to configure Lane Departure Warning for Bendix AutoVue…