Here is the instruction show you guide on how to setup diagnostic adapter communication for Doosan e-Doctor EDIA diagnostic software.
Related Contents:
Doosan Data Monitoring System DMS-5 DMS-3 Free Download
Doosan e-Doctor 2.4.0.7 2023.06 100% Work
Start Communication / Stop communication
Start communication icon
– Make the EDIA and engine ECU communicate.
– Let you know what engine is installed on machine.
Stop communication icon
– Make the communication stop.
※ Wait 5 seconds before resuming the communication.
Communication port selection
COM1 : Connect the main harness cable (which is connected to a gateway module) to the serial port #1 of your laptop computer.
COM2 : Connect the main harness cable (which is connected to a gateway module) to the serial port #2 of your laptop computer.
USB : Connect the USB cable (which is connected to a gateway module) to the USB port of your laptop computer.
More topics for Doosan,please refer to:Doosan Trouble Repair
Here is the instruction show you guide on how to replace fuel tank breather filter…
FENDT 900 Vario COM III tractor Component B092 - Sensor, charge air pressure/temperature reports the boost…
Deutz EMR3 Engine Trouble Code 87 / 97 / FlFCD WATER IN FUEL Solution Error description…
This instruction show you guide on how to perform hydraulic flow test for Kubota L3301…
This instruction show you guide on how to configure Lane Departure Warning for Bendix AutoVue…
This instruction show you guide on how to solve AGCO machine SPN102 FMI03 boost pressure…