How to Reset the Transmission Control Module(TCM) in Mercedes(1996-2016)

This instruction will show you guide on how to reset the transmission control module in all Mercedes vehicles from 1996 to 2016. This procedure is going to work on any Mercedes that has the five speed or the seven speed transmissions. The five speed is the seven to two point six and the seven speed is the seven to two point nine transmissions.

Please note this is not going to reset the check engine light there’s any issue with the transmission, it’s not going to remove any actual problems, it just resets the transmission adaptive shift learning.

More information about Mercedes, Please refer to BENZ TROUBLE REPAIR.

Procedure:

Turn the key to the on position two clicks until you see all the lights on the dashboard come on like this

Press gas pedal down, pass kick down switch and hold for 10 seconds.

After 10 seconds, turn the key back off and release gas pedal

Don’t do anything in the car, include open doors, mess with any accessories, play with your phone or read a book etc. Just wait for two full minutes.

This it the procedure to reset the transmission.

Kevin

Recent Posts

Doosan Machine Timeout Error of CAN Receive Frame AUXIO1

Here show you guide on how to solve Doosan machine Timeout error of CAN receive…

15 hours ago

Liebherr Machine Emergency Stop-Ignition on While Emergency Stop is Active

This instruction show you guide on how to solve Liebherr machine emergency stop ignition on…

1 week ago

How to Solve Doosan Machine U043D CAN Receive Frame Counter Error

This instruction show you guide on how to solve Doosan machine trouble code U043D message…

2 weeks ago

AGCO Machine Trouble Code SPN 1485 – FMI 03 Solution

Here is the instruction show you guide on how to solve AGCO machine trouble code…

3 weeks ago

Detroit DD13 J1939 Wheel-Based Vehicle Speed Sensor Signal Missing

Detroit DD13 EPA10 (2010-13) trouble code SPN 84 FMI 13 (MCM) J1939 Wheel-based vehicle speed…

1 month ago

How to Solve Caterpillar C9 Vehicle Speed Signal Invalid?

This instruction show you guide on how to solve Caterpillar C9 engine trouble code 36…

1 month ago