In this instruction car-auto-repair.com show you guide on how to check and replace steering angle sensor for Still Steds iGo Neo forklift truck.For more Still forklift repair,please refer to:Still forklift trouble repair.
Related Contents:
STILL STEDS Forklift 8.20 8.18 2020 EPC & Diagnostics Free Download
Checking the steering angle sensor
Checking the steering angle sensor A green status LED(1) shows the operational readiness of the steering angle sensor. The LED must light up continuously.
The function of the steering angle sensor can also be checked using the service diagnostics.
Replacing the steering angle sensor
-Disconnect the battery male connector.
-Disconnect plug 7X53 from the steering angle sensor.
The steering angle sensor(1) is mounted on the shaft (3) with two grub screws(2).
-Loosen the grub screws and remove the steering angle sensor from the shaft together with the support(4).
-Remove four screws(5) and the steering angle sensor from the support.
To install the steering angle sensor, follow the steps for removal in the reverse order.
After a sensor fault or replacement, the following service diagnostics functions must be per-
formed:
Calibrate the steering system
Carry out a reference drive
The supply module (SM) is a part of the vehicle SCR system. The SM is…
Yale G807 Brake System Air Bleed Guide Related Contents: 2023 Yale PC Service Tool…
This instruction show you guide on how to solve Bobcat G2 Stage V engine P000F…
Here is the instruction show you guide on how to solve CASE 7120 IH 20…
If the battery becomes discharged or does not have enough power to start the engine,…
Here is the instruction show you guide on how to solve Liebherr machine trouble code…