Categories: Do It YouselfHow To

How to Replace New Battery for BMW E90

This post show the guide on how to replace a new battery for BMW e90,though appearances may vary,the main process is similar for most.Follow this guide,not only save your dozen money and time,but also enjoy your DIY work!

 

What you need?

New BMW Battery about

Socket wrench – 10mm and 13mm sockets

Screwdriver

Eye goggles (for eye protection from exploding battery)

(Disclaimer – Car batteries can explode, so consider professional installation)

 

Procedures:

1)Open up the trunk,on the right side turn the knob to open up the battery compartment

2)Remove the top brace by removing the bolts at each end

3)Loosen (not remove) the nut securing the negative terminal to where the clamp can wiggle loose and remove

4)Disconnect the black plug on top with screwdriver

5)Disconnect the blue and blank plugs with screwdriver head by pressing down on clips

6)Pop open this door with screwdriver

7)Remove nut

8)Unclip the two metal clips on each side of the battery with screwdriver by pressing outwards from the battery.The whole black piece should pull off once these are unclipped.

9)Pop open the red box to the positive terminal with screwdriver tip

10)Loosen (not remove) the nut securing the positive terminal to where you’re able to wiggle the red box off the battery

11)Remove the tiny plug on the left side of the battery.

12)On the right side,there is a bolt that secures the battery and a foam cushion.UInscrew and remove the cushion and bolt.

13)I taped all the cables back to keep them out of the way since you’ll need toth hands to pull the battery out.Now you can replace the battery.

Once the battery is replaced,remove the red cap from the positive terminal,and reverse the steps to complete the installation.(and don’t forget about the tiny plug on the left side)

 

Finally,don’t forget to register the new battery,here are some post about how to register BMW new battery.

Rheingold ISTA Register New Battery for BMW F10

How To Use INPA Register BMW 7 Series New Battery

How to register a new BMW Battery after replacement

How to use Autel MD808 Pro Manage BMW Battery

2024.08 BMW Rheingold ISTA+ 4.48.40 4.23.14 ISTA-P 3.71 Free Download

auto

Recent Posts

How to Inspect and Clean Cylinder Block for John Deere PowerTech 9.0 OEM Engine

This instruction show you guide on how to inspect and clean cylinder block for John…

22 hours ago

How to Remove and Replace Cab Heater Controls for JCB 3CX Loader

Here is the instruction show you guide on how to remove and replace cab heater…

3 weeks ago

How to Remove Differential Gear for FENDT 900 Vario COMIII

Here is the instruction show you guide on how to remove differential gear for Fendt…

3 weeks ago

International MaxxForce 7 SPN 27 FMI 4 EGRP Signal Out of Range Low

This instruction show you guide on how to solve International MaxxsForce 7 SPN 27 FMI…

4 weeks ago

2025.08 BMW ISTA 4.54.40/4.02.14 ISTA-D Rheingold for BMW ICOM

BMW ISTA-D Rheingold 4.54.40/4.02.14 Standalone / SDP 4.02.13 / ISTA-P 3.60.0.600 free download link and…

4 weeks ago

Detroit DD13 SPN 84 FMI 3 MCM Vehicle Speed Sensor Open Circuit

This instruction show you guide on how to solve Detroit DD13 engine SPN 84 FMI…

1 month ago