Categories: Auto Repair

How to Repair Lexus GS-F & RC-F Abnormal Noise from Low Pressure Fuel Pump

Some 2015 – 2016 model year RC F and 2016 GS F vehicles may exhibit an abnormal buzzing noise condition from the low pressure fuel pump. The Engine Control Module (ECM) logic has been modified to reduce the possibility of this condition. Please follow the Repair Procedure below to address this condition.More about Lexus repair,please check:Lexus Trouble Repair

Note:This repair is covered under the Lexus Federal Emission Warranty. This warrantyis in effect for 96 months or 80,000 miles, whichever occurs first, from the vehicle’sin-service date.

Parts Information:

Note:The ECM (PCM) should NOT be replaced as part of the Repair Procedure.

 

Repair Procedure

1.Confirm the condition.If the noise is NOT originating from the low pressure fuel pump, disregard this Service Bulletin and continue diagnosis per the Repair Manual.

2.Using Techstream, confirm calibration ID. If the calibration ID listed IS the latest ECM (PCM) calibration, disregard this Service Bulletin and continue diagnosis per the Repair Manual.

3.Check for the Authorized Modifications Label affixed to the vehicle in the location shown below. Confirm if the ECM (PCM) calibration has been updated. If the calibration ID listed is NOT the latest ECM (PCM) calibration – go to step 4. If the calibration ID listed IS the latest ECM (PCM) calibration, disregard this Service Bulletin and continue diagnosis per the Repair Manual.

 

4.Flash reprogram the ECM (PCM).

NOTE:DTCs may set during software update. If DTCs set, please clear the codes at the completion of the update. If DTCs remain after clearing, please perform a 12V battery reset on the vehicle.

 

5.Install the Authorized Modifications Label.

A.Using a permanent marker, enter the following information on the label:

  • ECM part number [Refer to the Parts Information section for the NEW PART NUMBER]
  • Calibration ID(s) [Refer to the Calibration Information section for the NEW CALIBRATION ID]
  • Dealer Code
  • Repair Date
  • Change Authority [This bulletin number]

B.Affix the Authorized Modifications Label to the vehicle at the location shown.

6.Test drive the vehicle to confirm the noise is no longer present.

auto

Recent Posts

How to Solve Liebherr Machine Power or Speed Reduction?

How to solve Liebherr machine trouble code P1188 power or speed reduction emission related failure.…

6 days ago

Doosan Machine Timeout Error of CAN Receive Frame AUXIO1

Here show you guide on how to solve Doosan machine Timeout error of CAN receive…

2 weeks ago

Liebherr Machine Emergency Stop-Ignition on While Emergency Stop is Active

This instruction show you guide on how to solve Liebherr machine emergency stop ignition on…

3 weeks ago

How to Solve Doosan Machine U043D CAN Receive Frame Counter Error

This instruction show you guide on how to solve Doosan machine trouble code U043D message…

4 weeks ago

AGCO Machine Trouble Code SPN 1485 – FMI 03 Solution

Here is the instruction show you guide on how to solve AGCO machine trouble code…

1 month ago

Detroit DD13 J1939 Wheel-Based Vehicle Speed Sensor Signal Missing

Detroit DD13 EPA10 (2010-13) trouble code SPN 84 FMI 13 (MCM) J1939 Wheel-based vehicle speed…

2 months ago