This instruction will show you guide on how to remove the stock OEM side mirror puddle lights on 2016 Mercedes-Benz W205 C300 and replace them with two unique Mercedes logo projector puddle lights.More DIY cases, please refer to Do It Yourself.
Steps:
Lights require resistor install to prevent flashing
Cut into the blue wire(power wire) and strip off the ends
Take shrink tube and cut it down to size to cover the joints
Take a resistor included in kit cut it in properly size and then wrap one end of the blue wire to one end of the resistor and the same for the other side.
Use solder iron to solder the joints
Slide the shrink tube over the joints and heat it up and shrink it down
For safety, disconnect the battery before installation
Removing the stock mirror covers, carefully pry the cover from black bottom trim, pry up the inside area of the cover,push the inside area of the cover forward to release
Pull off signal light connector
Disconnect here
Pull off the original OEM light
Install the new light (driver’s side = “L” side),
The lens should be perfectly aligned on the bottom
Reinstall the mirror cover. Check out how it looks
More cases about Benz, welcome to visit BENZ.
Here is the instruction show you guide on how to solve Deutz EMR3 engine fault…
This instruction show you guide on how to solve AGCO machine trouble code 138 SPN…
Here is the instruction show you guide on how to install the left-hand drum bearing…
This instruction show you guide on how to remove and replace loader lift ram for…
This instruction show you guide on how to solve Caterpillar C9 engine 31 84-1 fault…
This instruction show you guide on how to charge and discharge accumulator for JCB 3CX,…