How to Download and Install JCB DLA 2.0 Driver?

It is necessary to do driver installation for JCB DLA 2.0 diagnostic kit,otherwise it can not work.This instruction show you guide on how to download and install JCB DLA 2.0 driver.

2017 JCB Parts Plus+ and Repair Service Manual Free Download

JCB DLA Diagnostic Kit

JCB DLA 2.0 will only be supported if you are running Servicemaster v21.3.1 or greater & executable version v4.11.5 or greater only.

Please update Servicemaster if you are running a version older than v21.3.1

You need Admin rights to complete DLA 2.0 setup procedure and for future use

Note: Only do this procedure if you have a DLA 2.0 kit or ordered one

1 Navigate to “Other”–>“General”–>“DLA”–>“DLA 2.0 Driver and guides

Left Click on “DLA 2.0 drivers” as shown in image

2.This will launch the setup for DLA 2.0 driver

Click on Next as highlighted

Click on Agree

Before proceeding further please unplug any DLA that is currently plugged into the laptop

Click on Next

Click on Finish as highlighted
Please restart the laptop before you proceed to the next step

Go to “C:\JCB_Servicemaster_2”
Right click on “Servicemaster.exe” file and select “Run as Administrator” as shown in the image.

In Servicemaster go to “Other->General->DLA”
Left Click on “USB DLA Chooser”. See image top right corner.
New window will open as shown in image bottom right corner.
Select the “DLA20R32” item & move it to the top of the box with the highlighted arrow on the right

Click “Apply” & then click on “Ok”.
You are now ready to use DLA 2.0

Now you can plug in DLA 2.0 and it should work the same as the old DLA

You can run Servicemaster as normal after this procedure & do not need to run it as Admin every time
If you want to use the Parker DLA please follow the procedure shown in the guide “How to switch between Parker & DLA 2.0”, this is available in Servicemaster v21.3.1 or greater under “Other”–>“General”–>“DLA”–>“DLA 2.0 driver and guides”

auto