Categories: Excavator Repair

How to Calibrate Wheel Alignment for Bobcat ToolCat

This instruction show you guide on how to use Bobcat Service Analyzer to to wheel alignment calibration for Bobcat 5600 A series ToolCat.More repair topic for Bobcat,please refer to:Bobcat Excavator Repair

2023 Bobcat Service Analyzer 91.15 91.05 Diagnostic Free Download

 

Procedures:

Connect Bobcat Service Analyzer software to Bobcat ToolCat

Then run software to select “Diagtnose/Calibrate”

With the all wheel steer mode selected turn the steering wheel until the angle sensor for the rear wheel reads zero.

Select the front wheel steer mode and turn the steer wheel until the front wheel sensor (Item 2)  reads zero.

Place a straight edge across the tires .Adjust the steering (if needed) so the tires are parallel with the straight edge

Select the Angle Sensor (Item 1)from the diagnose/calibrate screen. This will zero out the angles on the machine.

NOTE:There will be a “Calibration Completed”message after the calibration is completed.

 

auto

Recent Posts

How to Solve Liebherr Machine Power or Speed Reduction?

How to solve Liebherr machine trouble code P1188 power or speed reduction emission related failure.…

2 days ago

Doosan Machine Timeout Error of CAN Receive Frame AUXIO1

Here show you guide on how to solve Doosan machine Timeout error of CAN receive…

1 week ago

Liebherr Machine Emergency Stop-Ignition on While Emergency Stop is Active

This instruction show you guide on how to solve Liebherr machine emergency stop ignition on…

2 weeks ago

How to Solve Doosan Machine U043D CAN Receive Frame Counter Error

This instruction show you guide on how to solve Doosan machine trouble code U043D message…

3 weeks ago

AGCO Machine Trouble Code SPN 1485 – FMI 03 Solution

Here is the instruction show you guide on how to solve AGCO machine trouble code…

4 weeks ago

Detroit DD13 J1939 Wheel-Based Vehicle Speed Sensor Signal Missing

Detroit DD13 EPA10 (2010-13) trouble code SPN 84 FMI 13 (MCM) J1939 Wheel-based vehicle speed…

1 month ago