Categories: Auto Repair

Benz S350 W221 ABR Control Module Programming by Launch X431

When ABR control module replacing,ABR can not work normally,upgrading ABR,you need to program it.So here i want to show you guide on how to use Launch X431 to program ABR module for Mercedes Benz S350 W211 Chassis.For more projects on Benz,please check here:Mercedes Benz Repair

 

What You Need?

Launch X431 Pro

 

Note:

1.Before executing this function, keep the vehicle battery not less than 12V and power adequate. When executing the programming , the device need connect the network.

2.During the execution of this function, do not abort by manual. Otherwise it will cause ABR Control unit cannot be used and other serve consequence.

3.Please do not ignore any prompt when coding.

 

Operation Procedure

1.Select Benz V48.11 above;

2.Select auto-search ;

3.Select ABR control unit;

4.Select control module programming function;

5.Note that the device prompts the control module for the execution of the program

6.After the confirmation condition is satisfied, the corresponding programming configuration file is downloaded from the network, and the network should be kept open

7.After the configuration file is downloaded, the control unit software version information and programming function execution conditions will be displayed

8.The programming operation is to code the control unit. If the action fails, the control unit module cannot be used properly. Click “yes” to start the programming operation

9.The programming interface shows the filename and programming progress that needs to be configured. The programming time may be longer.

10.Hint after encoding has been successful, according to the equipment, some models will be prompted to close the ignition, after waiting for ten seconds to open the ignition switch, X431 device will reset to complete the control unit module,. The online coding has been completed.

More test report about Launch X431 please check:Launch X431 Test report

auto

Recent Posts

How to Solve Liebherr Machine Power or Speed Reduction?

How to solve Liebherr machine trouble code P1188 power or speed reduction emission related failure.…

2 days ago

Doosan Machine Timeout Error of CAN Receive Frame AUXIO1

Here show you guide on how to solve Doosan machine Timeout error of CAN receive…

1 week ago

Liebherr Machine Emergency Stop-Ignition on While Emergency Stop is Active

This instruction show you guide on how to solve Liebherr machine emergency stop ignition on…

2 weeks ago

How to Solve Doosan Machine U043D CAN Receive Frame Counter Error

This instruction show you guide on how to solve Doosan machine trouble code U043D message…

3 weeks ago

AGCO Machine Trouble Code SPN 1485 – FMI 03 Solution

Here is the instruction show you guide on how to solve AGCO machine trouble code…

4 weeks ago

Detroit DD13 J1939 Wheel-Based Vehicle Speed Sensor Signal Missing

Detroit DD13 EPA10 (2010-13) trouble code SPN 84 FMI 13 (MCM) J1939 Wheel-based vehicle speed…

1 month ago