This instruction show you guide on how to connect Dr.ZX diagnostic tool to computer and Hitachi excavator.
Preparations:
Hitachi MPDr v2.56 v2.25 Diagnostic Software Free Download
Procedures:
Cable Connection
1.Connect a personal computer installing MPDr. to the connector in the cab (refer to the below illustration) with a USB serial cable, an interlink cross cable, and a connecting harness.
2.Turn the key switch ON or start the engine.
Connecting Harness
Part No.: 3108613 (ZX-5/ZW-5/ZX-3/ZW)
Interlink Cross Cable
Part No.: 4668565
Please locally procure an USB serial cable.
ZX-3 Series (Except US, USR)
Wheel Excavator
ZX-3 US and USR Series
ZX-5 Series
Crawler Excavator
ZX-6 Series
Checking the Communication Port
“When starting the MPDr. for the first time, the communication port must be set.” Check the communication port on the PC.
This operation is required only for the first time.
The procedure on the Windows 7 is explained here.
1.Right click the [Computer] icon and then click the[Properties] menu.
2.Click the [Device Manager] menu.
3.Check the COM number of [USB Serial Port].
JCB Engine Fault Derate When a fault is detected, the ECU determines the severity of…
Here is a instruction show you guide on how to solve Liebherr ECU 2 D966…
AGCO EEM5 DEF Suction Module Tank sensor (CAN) The DEF suction module with the CAN-bus…
This instruction show you guide on how to remove the threshing drum for CLAAS Lexion…
This instruction show you guide on how to display service menu for Hitachi ZX890-7 excavator.…
Here is the instruction show you guide on how to do Advanced Tool Select and Basic…