Here is the instruction show you guide on how to perform urea water pipe leak test for HITACHI ZX-6 excavator.
What You Need?
Hitachi AllinOne MPDr v3.32 v2.25 2021 Diagnostic Software Free Download
Procedures:
1 Click [Urea Water Pipe Leak Test].
2 Click [Start].
The forced operation is continued while “Executing” is displayed.
After checking leakage, click [Stop] button.
Click [Stop] if you want to stop the forced operation.
DEF/AdBlue piping leak test can not be enforced whie the engine is running.
Enforce it only when the key switch is ON
It can not be enforced when the DEF/AdBiue tank temperature or the DEF/AdBlue supply module temperature is -5degC or lower.
Enforce it after warming up the machine and the DEF/AdBlue tank temperature and DEF/AdBlue supply module temperature is SdegCor higher.
[Procedures]
1) Turn the key switch ON. (Be sure not to start the engine.)
2) Press the [Execution] button.
3)The pump of DEF/AdBiue supply module cperates and increases the DEF/AdBlue pressure to 900 kPa.
4)Ensure that no DEF/AdBlue leakage from the DEF/AdBlue piping or dosing module.
5)Aner checking leakage. press the [5!op] button.
Turn the key switch OFF.
More repair case for Hitachi,please refer to Hitachi excavator trouble repair
How to solve Liebherr machine trouble code P1188 power or speed reduction emission related failure.…
Here show you guide on how to solve Doosan machine Timeout error of CAN receive…
This instruction show you guide on how to solve Liebherr machine emergency stop ignition on…
This instruction show you guide on how to solve Doosan machine trouble code U043D message…
Here is the instruction show you guide on how to solve AGCO machine trouble code…
Detroit DD13 EPA10 (2010-13) trouble code SPN 84 FMI 13 (MCM) J1939 Wheel-based vehicle speed…