If vehicle battery was disconnected or Powertrain Control Module (PCM) was replaced, driving the vehicle will enable the PCM to perform a computer relearn procedure for obtaining proper drivability and engine idle. Until PCM has completed computer relearn procedure, drivability or idle may differ from standard vehicle operation. On A/T models, transaxle shift qualities must be relearned. And for more GM vehicles projects,check here:GM vehicle repair cases
Procedures
1On all models, start engine and warm engine to normal operating temperature. Perform 10 sets of upshifts (1-2, 2-3 and 3-4) at about 30 percent throttle.
2On DOHC engine, while coasting at 35 MPH, slowly accelerate to 1/2 throttle to achieve a 4-3 downshift. Place gearshift in “D3” while coasting at 20 MPH, slowly accelerate at 3/4 throttle to achieve a 3-2 downshift.
3Repeat step 2) five times. Vehicle drivability computer relearn procedure is now complete.
4On SOHC engine, while coasting at 40 MPH, slowly accelerate to 1/2 throttle to achieve a 4-3 downshift. Place gearshift in “D3” while coasting at 30 MPH, slowly accelerate at 1/2 throttle to achieve a 3-2 downshift.
5Repeat step 4) five times. Vehicle drivability computer relearn procedure is now complete.
Detroit DD13 EPA10 (2010-13) trouble code SPN 84 FMI 13 (MCM) J1939 Wheel-based vehicle speed…
This instruction show you guide on how to solve Caterpillar C9 engine trouble code 36…
Kubota L3301 L3901 Excavator Safety Valve Setting Pressure Test Using Injection Nozzle Tester 1 Remove…
JCB Engine Fault Derate When a fault is detected, the ECU determines the severity of…
Here is a instruction show you guide on how to solve Liebherr ECU 2 D966…
AGCO EEM5 DEF Suction Module Tank sensor (CAN) The DEF suction module with the CAN-bus…