This mini post show a guide on how to use GM Tech2 to perform adaptives reset for GM Saturn.
Related Contents:
Original & Crack GM Tech2Win Software Installation Guide
GM Tech2Win Software Free Download
How to Install GM GDS2 Software on Win XP/7/8
Follow this procedure using a Tech2.
1.Turn ignition switch to the ON position (engine off).
2.Connect Tech2.
3.Identify the vehicle.
4.Select DYNAMIC DISPLAY from main menu.
5.Select VIEW DATA.
6.Select PCM/ECC.
7.Select VEHICLE ID TABLE.
8.Select Reset Adaptives.
9Turn ignition switch to the OFF position for ten seconds.
10.Crankshaft Position Relearn must be performed next.
IMPORTANT NOTE: Refer to your vehicle’s service manual for detailed relearn procedures specific to your application.
This instruction show you guide on how to solve Caterpillar C9 engine trouble code 36…
Kubota L3301 L3901 Excavator Safety Valve Setting Pressure Test Using Injection Nozzle Tester 1 Remove…
JCB Engine Fault Derate When a fault is detected, the ECU determines the severity of…
Here is a instruction show you guide on how to solve Liebherr ECU 2 D966…
AGCO EEM5 DEF Suction Module Tank sensor (CAN) The DEF suction module with the CAN-bus…
This instruction show you guide on how to remove the threshing drum for CLAAS Lexion…