Categories: Auto Repair

G-San2:Peugeot 307 Risk of ice Particle Filter Additive Level Too Low Repair

When DPF additive level is too low,the vehicle will display “Risk of ice Particle filter additive level too low” massage on the console.You need to replace DPF additive reservoir,and perform resetting operation by G-scan2.

 

Procedures:

The vehicle needs to be lifted up when refilling the additive.

Remove all the covers to get access to the reservoir

Take out the reservoir

Begin refilling the additive using the tube

 

Reinstall the reservoir back

Put every back together on vehicle

Connect G-scan2 to vehicle OBD port

Select “Diagnosis” option

Select “Peugeot”

Select “307”

Select “Engine/Automatic Gearbox”

Select Engine according to the 6th-8th digit of VIN

Select “RHR SIEMENS SID 803” then click “OK”

Select “Special Function” & “Filling of the Additive Reservoir”

 

It prompt you with the massage “Fill of the additive reservoir-Initialisation of the additive level”

Operation finished

Then you test whether the warning massage is gone

Pull out the key,then insert it again to start the ignition

Done!

auto

Recent Posts

Valtra BH Series 140-210 Trouble Internal Roll inertial Sensor Fault

This instruction show you guide on how to solve Valtra BH Series 140-210 trouble code SA…

5 days ago

Caterpillar C9 Engine Throttle Position Out of Calibration 28 91-13 Trouble Solution

This instruction show you guide on how how to solve trouble code 28 PID 91-13…

1 week ago

Magneti Marelli 1 AVB-VW ECU Pinout

Vehicles: With AP 1.6, 1.8 and 2.0 Ml engines DE 97 to 99. And for…

1 week ago

Valtra BH Series 140-210 Internal lateral Inertial Sensor Recalibration

This instruction show you guide on how to solve Valtra BH Series 140-210 trouble code SA…

2 weeks ago

Bendix AutoVue 3G LDW System Driver Assistance Systems (DAS) Tests

JPRO 2025V3 Driver Assistance Systems (DAS) Tests allows the editing of configuration parameters.   Related Contents:…

2 weeks ago

How to Solve PCC2300 PowerCommand Membrane Buttons Not Functioning

This instruction show you guide on how to solve PCC2300 Powercommand Membrane buttons not working.…

3 weeks ago