Several days,I search the info about Ford F150 throttle response calibration,and find this cool post.So I put it here to share.Big thanks to the F150ecoboost.net member Sirikenewtron.Below is the original content.
Not sure if this has been posted, I tried searching for it.
I do this about once a week or every other week and it’s pretty amazing how much better throttle response I get after doing this. It is for sure noticeable for me and after doing it this morning I noticed my gears held longer when shifting, (for the better) , I actually had to double check to see if I was in t/h mode.
Copied and pasted this from f150 forum ;
Throttle Calibration
Throttle calibration can substantially improve throttle responsiveness over “factory standard.” Many people notice what appears to be sluggish throttle response or a “dead area” at initial accelerator depression. Throttle calibration can take care of these.
1) turn the key in the ON position (don’t start the engine)
2) press the gas pedal down slowly all the way down
3) let go of the gas pedal fast so it come back up
4) turn key into the OFF position
Repeat steps 1-4 two more times then start engine.
Most drivers notice an immediate change in throttle response, but depending on your driving style, you may need to repeat this procedure periodically due to the computer’s adaptive programming. You likely need to repeat this procedure any time the battery is disconnected.
And more articles about throttle :
How to Adjust/Calibrate Throttle Position for Benz 212 2014
How To Clean Throttle Body By Yourself (Step By Step)
How to Remove & Install Auto Throttle Body
Here is the instruction show you guide on how to replace fuel tank breather filter…
FENDT 900 Vario COM III tractor Component B092 - Sensor, charge air pressure/temperature reports the boost…
Deutz EMR3 Engine Trouble Code 87 / 97 / FlFCD WATER IN FUEL Solution Error description…
This instruction show you guide on how to perform hydraulic flow test for Kubota L3301…
This instruction show you guide on how to configure Lane Departure Warning for Bendix AutoVue…
This instruction show you guide on how to solve AGCO machine SPN102 FMI03 boost pressure…