Doosan DMS-5 FAD1005 “Not Response from ECU” Solution

Doosan DMS-5 diagnostic software allow you connect ECU to do some parameters programming,but something you will get fault code FAD1005 “Not response from ECU”,here give the solution.

Related Contents:

Doosan Data Monitoring System DMS-5 DMS-3 Free Download

Doosan Diagnostic Tool

 

Solution:

There is no response from the ECU.

• Make sure the power is supplied to the ECU. (Equipment driven state)
• Check the communication status. (Cable, Connector tightening status.)
• Make sure you have the same notification also occurs in the Gauge panel

– If the same occurs in the gauge panel alerts,check the communication connection between the

ECU.

• Make sure that the ECU information of the ECU and the equipment selected in the program the

same model.

• Verify that the problem also perform other functions.
• If you have problems in performing other functions, please contact the administrator for the notification.

 

More topics for Doosan,please refer to:Doosan Trouble Repair