The Engine Control Module(ECM) detects the following conditions:
The voltage for the injection actuation pressure circuit is greater than 4.8 VDC for more than 0.6 seconds.
Cold mode is not active.
Related Contents:
Caterpillar ET 2024A 2023A 2018A Diagnostic Software Free Download
CAT Communication Adapter 3 478-0235
Caterpillar Factory 18 Digits Password Service
The injection actuation pressure sensor measures the pressure of the oil in the high pressure oil manifold. The high pressure oil in the manifold is used to actuate the injectors and the high pressure oil is used to control the fuel injection pressure. Fuel injection pressure is based on inputs from the sensors. The inputs are used by the Engine Control Module (ECM) for calculating the fuel injection pressure. The ECM uses the reading from the injection actuation pressure sensor in order to control the operation of the injection actuation pressure control valve.
Probable Causes:
1)ECM Connection
2) Injection actuation pressure sensor
3) Injection actuation pressure sensor wiring/connection
More repair case for Caterpillar machine,please refer to:Caterpillar Machine Repair
Here is the instruction show you guide on how to do Advanced Tool Select and Basic…
Here car-auto-repair.com show you guide on how to solve P1161 trouble code on resistance error…
AGCO EEM Dosing module Description The dosing module (DM) is installed in the exhaust…
Here is the instruction show you guide on how to solve Caterpillar C9 fault code 64-2…
This instruction show you guide on how to bleed air from the fuel system for…
This instruction show you guide on how to solve Doosan and Bobcat Electric problems can…