Rear Combination Lamp Assy LH Overhaul
Hint:
Use the same procedures for the RH side and LH side
The procedures listed below are for the LH side.
Installation is in the reverse order of removal
1. Remove Luggage Compartment Trim Hook No.1
2. Remove Rear Floor Finish Plate.
3. Remove Rear Combination Lamp Assy LH
A)Disconnect the connector
B)Remove the 3 nuts and the rear combination lamp assy LH
C)Remove the rear combination lamp gasket RH.
4. Remove Rear Combination Lamp Bulb
A)Turn in the direction indicated by the arrow and remove the 3 rear combination lamp socket & wire sub-assy RHs and the 3 rear combination lamp bulbs as a unit.
B)Remove the 3 rear combination lamp bulbs from the 3 rear conbination lamp socket & wire sub-assy RHs.
5. Remove Rear Combination Lamp Bulb
A) Turn in th direction indicated by the arrow and remove the rear combination lamp scoket & wire sub-assy RH and the rear combination lamp bulb as a unit.
B)Remove the rear combination lamp bulb from the rear combination lamp socket & wire sub-assy RH.
When you use IDSS diagnostic scan to do some function,it may occur communication error.Sometime you…
Deutz engine EOL test (end of line) is required to ensure the EAT functionality. Conditions…
This instruction show you guide on how to solve Scania truck articulation control system ACS…
Magneti Marelli 49FB – Fiat ECU Pinout More ECU PINOUT Components: ECU Modules Repair…
After ECU reparogramming,it is necessary to write new engine number and machine ID into ECU.So…
PCC1302 PowerCommand Low Coolant Level (Warning or Shutdown) Solution Related Contents: 2024 InPower V14.5…