After replacing the steering wheel related parts and sensors,in the event of a related failure, you need to perform calibration.So here I will show you the guide on how to use Launch X431 to calibrate steering angle sensor for Cadillac XTS 2013.For more repair case about Cadillac,please check here:Cadillac Repair Cases
What You Need?
Operation Procedures:
1) Choose SGM software, use “Automatically search”, find “Quick test”,to scan all system inside the car
2) Choose “EPS”
3) Choose “Special function”
4) Find “Center steering wheel angle sensor”, press “Yes” to continue
5) Start engine” to continue
6) Read the prompt”Slowly left, and then slowly to the right, last back to the steering wheel”
7) Function finished.
More test report about Launch X431 please check:Launch X431 Test report
Detroit DD13 EPA10 (2010-13) trouble code SPN 84 FMI 13 (MCM) J1939 Wheel-based vehicle speed…
This instruction show you guide on how to solve Caterpillar C9 engine trouble code 36…
Kubota L3301 L3901 Excavator Safety Valve Setting Pressure Test Using Injection Nozzle Tester 1 Remove…
JCB Engine Fault Derate When a fault is detected, the ECU determines the severity of…
Here is a instruction show you guide on how to solve Liebherr ECU 2 D966…
AGCO EEM5 DEF Suction Module Tank sensor (CAN) The DEF suction module with the CAN-bus…