Categories: Auto Repair

Autocom CDP+ Reset Counter for Additive Level for Peugeot 308 2010

This mini post show you how to use Autocom CDP+ reset counter counter for additive level for Peugeot 308 2010.

 

Procedures of Resetting Counter for Additive Level:

Connect Autocom CDP+ to Peugeot 308

Then run autocom software and enter to select vehicle model

Brand:Peugeot

Model:308

Year model:2010

Type of system:Diesel

Engine code:Additive system

System:Multiplex

 

Then it will show you conditions:

1.Turn ignition on or start the engine

2.Start measuring

3.Choose the test or tests you want to perform

4.Exit measuring

5.Turn ignition off

Click “OK” to continue

 

When communication established

Choose function by using the buttons in the left menu

Tip:Move themouse pointer over the buttons to see a hint describing the function

Click the “Adjust” button in the left menu

Now select “Replacement of the additive tank”

 

Then it will show you screen as below,and please check the help information,after then click “OK” button to start resetting.

Help information:

This function is used to restore the counter for calculating additive level in the reservoir.The function shall only be done after replacement or filling additive reservoir according to service instructions for the car.Only change to reservoir of same volume.

Test conditions:

Ignition on,engine off.

All power consumers disconnected.

Battery voltage above 12V

Additive reservoir replaced or filled

 

Procedures:

1.Start the function

2.Follow the instructions in the programme.

3.Finish and disconnect the diagnostics unit

4.The function is done

If the function failed,check test conditions and resolve any error codes.

auto

Recent Posts

How to Solve Liebherr Machine Power or Speed Reduction?

How to solve Liebherr machine trouble code P1188 power or speed reduction emission related failure.…

5 days ago

Doosan Machine Timeout Error of CAN Receive Frame AUXIO1

Here show you guide on how to solve Doosan machine Timeout error of CAN receive…

2 weeks ago

Liebherr Machine Emergency Stop-Ignition on While Emergency Stop is Active

This instruction show you guide on how to solve Liebherr machine emergency stop ignition on…

3 weeks ago

How to Solve Doosan Machine U043D CAN Receive Frame Counter Error

This instruction show you guide on how to solve Doosan machine trouble code U043D message…

4 weeks ago

AGCO Machine Trouble Code SPN 1485 – FMI 03 Solution

Here is the instruction show you guide on how to solve AGCO machine trouble code…

1 month ago

Detroit DD13 J1939 Wheel-Based Vehicle Speed Sensor Signal Missing

Detroit DD13 EPA10 (2010-13) trouble code SPN 84 FMI 13 (MCM) J1939 Wheel-based vehicle speed…

2 months ago