Heavy Equipment Repair

Allison 3000 & 4000 Gen5 Transmission Range Sensor Circuit High

This instruction show you guide on how to repair Allison 3000 & 4000 Gen5 fault code P0708 transmission range sensor circuit high.

 

Related Contents:

2023 Diesel DTC Solutions V2.9.98+ Diesel Explorer 2.0+Instruction

2024 2019 Allison DOC Transmission Diagnostic Software Free Download

 

 

DIAGNOSTIC RESPONSE:

Ignore defective strip selector inputs

 

CIRCUIT DESCRIPTION:

This test monitors whether the transmission range data from the analog strip shift selector is valid.

 

ACTION TAKEN WHEN THE DTC SETS:

When the DTC P0708 is active, the following conditions occur:

1 The DTC is stored in the TCM history.

2 The TCM illuminates the CHECK TRANS light.

3 The TCM ignores input from the analog strip shift selector.

4 Locks in N (Neutral).

 

CONDITIONS FOR CLEARING THE DTC/CHECK TRANS LIGHT:

Use the diagnostic tool to clear the DTC from the TCM history. The TCM automatically clears the DTC from theTCM history if the vehicle completes 40 warm-up cycles without the DTC recurring.

 

DIAGNOSTIC AIDS:

This DTC may be caused by:

1 Short to power or short to another wire in W114,W138,W153, or W173.

2 High resistance or open in W114, W138,W153, or W173.

3 Poor yehicle grounds.

4 Unlocked connectors, expanded terminals, poor pin crimps or unlocked pins causing high resistance or open circuit.

5 Unlocked connectors, unlocked pins, causing shorts in connectors.

6 TCM ground is at different voltage potential than the ground of the OEM voltage source responsible for strip shift selector.

7 Defective TCM.

8 Defective strip shift selector.

More Allison repair case,please refer to Allison Trouble Repair

auto

Recent Posts

How to Solve Liebherr Machine Power or Speed Reduction?

How to solve Liebherr machine trouble code P1188 power or speed reduction emission related failure.…

5 days ago

Doosan Machine Timeout Error of CAN Receive Frame AUXIO1

Here show you guide on how to solve Doosan machine Timeout error of CAN receive…

2 weeks ago

Liebherr Machine Emergency Stop-Ignition on While Emergency Stop is Active

This instruction show you guide on how to solve Liebherr machine emergency stop ignition on…

3 weeks ago

How to Solve Doosan Machine U043D CAN Receive Frame Counter Error

This instruction show you guide on how to solve Doosan machine trouble code U043D message…

4 weeks ago

AGCO Machine Trouble Code SPN 1485 – FMI 03 Solution

Here is the instruction show you guide on how to solve AGCO machine trouble code…

1 month ago

Detroit DD13 J1939 Wheel-Based Vehicle Speed Sensor Signal Missing

Detroit DD13 EPA10 (2010-13) trouble code SPN 84 FMI 13 (MCM) J1939 Wheel-based vehicle speed…

2 months ago