This instruction show you guide on how to use AGCO EDT diagnostic software to do VALTRA machine configuration.
Preparations:
AGCO EDT Configuration Function
Go to the Configuration tab and select an item from the list. Press the Start icon (1) to run the Configuration script of the selected item through a sequence of steps. Follow the instructions given by EDT.
Available functions for Valtra Suolahti vehicles under the Configuration tab vary depending of the tractor model:
– Save TC1 indexes to EDT
– Load TC1 indexes to EDT
– Update TC1 indexes with latest factory values
– Adjust TC1 indexes
– Adjust Tractor Terminal Indexes
– Reset Tractor Terminal User Settings
– Change the identifier (CAN ID)
– Hydraulic Configuration
– Tractor number
– Valve head management
– VIN Setup
– Cooling Fan Setup
– Engine Service Parameter Configuration
– Use Engine Activation Code
– Bypass Specification Mismatch
NOTE: See the machine special instructions for the information on how to use these functions from Valtra Info.
This instruction show you guide on how to solve Doosan and Bobcat Electric problems can…
It is necessary to do driver installation for JCB DLA 2.0 diagnostic kit,otherwise it can…
Here is the instruction show you guide on how to solve Deutz EMR3 engine fault…
This instruction show you guide on how to solve AGCO machine trouble code 138 SPN…
Here is the instruction show you guide on how to install the left-hand drum bearing…
This instruction show you guide on how to remove and replace loader lift ram for…